How the numbers are worked out
Where the density scale comes from, what the calculator can and cannot tell you, and what the bill of lading generator produces.
Freight class
- Cubic feet for each line: length × width × height in inches ÷ 1,728, multiplied by the number of pieces.
- Density for each line: weight in pounds ÷ cubic feet.
- Class: the step of the NMFC density scale that contains that density.
Every line is worked out on its own, because carriers usually rate each handling unit by its own density. When lines fall into different classes, the result says so instead of showing one average class. The average density of the whole shipment is still shown, since some paperwork carries only a total weight.
The scale we use
The standard density scale with 13 subprovisions, in force since July 19, 2025 under NMFTA Docket 2025-1. Subprovisions 11 to 13 (classes 60, 55 and 50) were confirmed against NMFTA's own FAQ; the full table was cross-checked against a second public source. Checked September 19, 2026.
- 400 Under 1 pcf
- 300 1 to under 2 pcf
- 250 2 to under 4 pcf
- 175 4 to under 6 pcf
- 125 6 to under 8 pcf
- 100 8 to under 10 pcf
- 92.5 10 to under 12 pcf
- 85 12 to under 15 pcf
- 70 15 to under 22.5 pcf
- 65 22.5 to under 30 pcf
- 60 30 to under 35 pcf
- 55 35 to under 50 pcf
- 50 50 pcf and up
What this does not tell you
- The NMFC item decides
- Many density-based items use this standard scale, some items have density breaks of their own, and others are classed by handling, stowability or liability instead. If your commodity has such an item, the class comes from the item.
- Carriers re-measure
- Carriers can reweigh and reinspect a shipment and bill it at a different class. An estimate here does not bind anyone.
- Measure as you ship
- Use the dimensions and weight of the handling unit as it will be tendered, pallet and overhang included.
Bill of lading
The generator produces a straight bill of lading, short form, not negotiable: the standard document for domestic LTL. It carries the shipper, consignee, carrier, freight charge terms, the commodity lines and the statements normally printed on such a form, including the liability note that refers to 49 U.S.C. § 14706 and the shipper certification required by the hazardous materials regulations.
It is filled in and printed by your browser. Nothing is uploaded. Some carriers ask shippers to use their own form, so check when you book. Classes brought over from the calculator are density estimates and are marked as such in the form.
Corrections
If a number here is wrong, write to andriy@sonnis.co with the input you used. The density scale is re-checked when NMFTA publishes a docket that touches it, and the check date is printed under the chart on the calculator page.